Adorable Knitted Duck Socks for Babies — Infant (3–9 mo) Pattern with Step-by-Step Photos
Make a sweet, cozy pair of duck-themed socks for an infant (3–9 months) with this detailed knitting pattern. This pattern includes finished measurements, recommended materials and needles, gauge, pattern notes (including increases and decreases), and full step-by-step directions for shaping the foot, gusset, heel, toes and cuff. Photographs illustrate key techniques such as Judy's Magic Cast On, Turkish cast on for the center point, applied I-cord toes, and closing the back of the heel. These socks are intended for babies who are not yet walking; see pattern notes for variations for an active toddler.

SIZE
Infant (3-9 months)
FINISHED MEASUREMENTS
Length of foot: 5 inches
Cuff circumference: 4.5 inches
MATERIALS
- Yarn
- Recommended needle size
- [always use a needle size that gives you the gauge listed below -- every knitter's gauge is unique]
- 2 US #2/2.75mm circular needles, 24 inches or longer
- Note: If preferred, double-point needles or one long circular needle (with magic loop technique) may be used instead.
- 1 set US #2/2.75mm double-point needles (only two are used, to work applied I-cord)
Notions
- Crochet hook, close in size to US #2/2.75mm
- Small stitch holders
- Yarn needle
- Elastic thread (optional)
GAUGE
32 sts/48 rows = 4" in stockinette st
PATTERN NOTES
| These socks are intended to be worn by babies who are not yet walking. For a variation designed for an active toddler.
LLI (Left Lifted Increase): Use the left needle to pick up the stitch 2 rows below the last stitch on the right needle. Knit into this stitch. 1 stitch has been increased. ![]() |
| DIRECTIONS FOOT
Round 2: CO 2 sts (1 st on each needle), k2 (first st to be knit is new CO st), p1, k1; CO 2 sts (1 st on each needle), k2, p1, k2. 10 sts. ![]() Shape Webbing: Begin Side Toes: Shape Foot: ![]() ![]() Round 1: P1, k8, LLI, k2, p1, k2, RLI, k8; p1, k8, k2tog, p1, ssk, k8. 44 sts: 24 sts on first needle, 20 sts on second needle. Rounds 2-3: [P1, k11] twice; [p1, k9] twice. Round 4: P1, k8, LLI, k3, p1, k3, RLI, k8; p1, k7, k2tog, p1, ssk, k7. 44 sts: 26 sts on first needle, 18 sts on second needle. Round 5-6: [P1, k12] twice; [p1, k8] twice. Round 7: P1, k8, LLI, k4, p1, k4, RLI, k8; p1, k6, k2tog, p1, ssk, k6. 44 sts: 28 sts on first needle, 16 sts on second needle. Rounds 8-9: [P1, k13] twice; [p1, k7] twice. Round 10: P1, k8, LLI, k11, RLI, k8; p1, k5, k2tog, p1, ssk, k5. 44 sts: 30 sts on first needle, 14 sts on second needle. Note that center st on first needle is knit, instead of purled. HEEL Row 1 [WS]: P8, k1, [p6, k1] twice, p8. Break yarn. With RS facing, divide remaining sts between 2 needles, placing first 9 sts on first needle and last 10 sts on second needle. Transfer sts to st holder, slipping sts purlwise and alternating sts from each needle as follows: [sl 1 st from second needle to holder, sl 1 st from first needle to holder] 9 times, sl last st from second needle to st holder. Alternating sts in this way closes back of heel; later on, applied I-cord will be worked over these sts. TOES Side Toes:
Using double-point needle, CO 3 sts. Row 1: Slide sts to other end of needle, switch needle to left hand, bring yarn around back of work and k3. Use tip of right needle to pick up 1 st just above yarnover at tip of side toe. 4 sts on right needle. Row 2: Slide sts to other end of needle, switch needle back to left hand, bring yarn around back of work; k2, k2tog tbl (last st of I-cord worked together with picked-up st). Use tip of right needle to pick up next p st in column. Repeat Row 2 until 2 p sts remain in column, including st on holder. (In diagram below, work st marked with red “3”, but not st marked with black “2”.) Do not pick up st at end of last row. Break yarn and place sts on st holder.
Center Toe: Note: Read next paragraph through and see photos below before proceeding. Using crochet hook and with work positioned as shown, draw a loop of yarn through each of the center 3 held instep sts (see below); ensure that tail of yarn is at left, with working yarn at right. Place these sts on double-point needle and bring yarn to front of work as shown.
Rotate work so that toes are pointing away from you. Place needle in left hand and slide sts to tip, ready to work I-cord; k3. Use tip of right needle to pick up next p st in column. Next Row: Slide sts to other end of needle, switch needle back to left hand, bring yarn around back of work; k2, k2tog tbl (last st of I-cord worked together with picked-up st). Use tip of right needle to pick up next p st in column. Repeat this row, working I-cord along top, over toe, then along bottom of foot, until you have attached I-cord to S2KP at base of heel. Do not pick up st at end of last row. There will be 3 held sts from each side toe to each side of sts on needle. Transfer these sts to needle, placing sts of side toes at either side of center toe sts. Divide sts between 2 needles as shown below, with first 4 sts on first needle and last 5 sts on second needle. Transfer sts to circular needle, alternating sts from each needle as you did at end of heel section. Working yarn will be attached to second st on needle.
Close Back of Heel:
CUFF Next Round: *K3, p2, [k2, p2] three times; repeat from * once. Repeat this round 15 times more, or until cuff is desired length.
FINISHING |













